With the Sidas Pro Set with Custom H Element foot warming system, you can keep your feet toasty warm from the first chair of the day to the last set of turns. The PRO batteries provide up to eight hours of warmth each, and three different heat settings allow you to fine-tune the temperature inside your boots.
- Includes two PRO batteries with charger that provide up to eight hours of warmth each
- Three heat levels allow you to adjust the temperature inside your boots
Share your thoughts
How Do I install these
Hi, I need new custom h heating elements....
Hi, I need new custom h heating elements. Can I buy them seperately?
Unfortunately we do not have separate H elements but If you go to the Sidas site I believe they have them available.
- Familiarity: I've put it through the wringer
Cold feet suck. A great day can easily be ruined by frozen toes. No matter how well your boots fit, low blood circulation will always prevail. In come this set of insoles. Feet are now warm, the day is saved! The best part about them is they mold to your feet so you still get the performance and fit out of a 'custom' footbed but with battery powered warmth. Make sure you keep them charged is all. Easy enough.
- Gender: Male
- Familiarity: I've used it several times
A friend bought these for his AT boots. After laughing at him at the start of the day, having numb toes all the way home in the car until I sat in front of the fire, persuaded me that boot heaters in an AT boot was a luxury worth having. These heaters last the prescribed 8 hours, are easy to use and clip nicely onto your boots' power-strap without the need for special adapters. They're pretty small and minimal, but keep the chill off my toes. Only note is that you need to ensure the connector gets pushed ALL the way into the battery unit - it was a little stiff at first. I'd buy another pair.
Does anyone know how to install the custom...
Does anyone know how to install the custom H insoles to the footbed? Does it go on top, underneath, etc...
The heating element goes on top at the front of the footbed. The red material shown in the photograph above is cover material to then go over the heating element. You stick the cover material over the top and then trip to the size of your footbed.
These do NOT come with custom insoles. Just with the heating element and cover material.
Do you need to cut a hole in the liner for the wire?